PRODUCT CARE INSTRUCTIONS
PRODUCT CARE INSTRUCTIONS
CLOTHING CARE INSTRUCTIONS
“Improper washing or drying may cause the print to crack, fade, or peel. Always follow the care instructions provided to ensure longevity.”
WASHING
- Turn the garment inside out before washing.
- Use cold water (30°C or lower).
- Select a gentle cycle with mild detergent.
- Avoid bleach, harsh stain removers, or fabric softeners.
DRYING
- For best results, air dry your garment.
- Do not tumble dry.
- Do not wring or twist the garment.
IRONING
- Do not iron directly on the print.
- If needed, turn the garment inside out or place a thin cloth over the print before ironing on a low setting.
- Avoid steam directly on the print.
GENERAL TIPS
- Do not dry clean.
- Store in a cool, dry place away from direct sunlight.
- Following these instructions will help your print stay vibrant and durable wash after wash.
VINYL PRODUCT CARE INSTRUCTIONS
Dry application requires patience and confidence — once applied, vinyl cannot easily be repositioned.
Check local regulations, as sunstrips may not be road-legal everywhere.
For the cleanest result, professional installation is recommended.
We cannot be held responsible for improper fitting, surface preparation, or legal restrictions.
DECAL APPLICATION PROCESS
1. PREPARE THE SURFACE
- Clean the area thoroughly with soap and water.
- Dry completely — moisture, dust, or coatings can prevent proper adhesion.
- Any glass sealants or ceramic coatings will affect adhesion.
- For best results, wipe with rubbing alcohol and let dry.
- Work in a shaded, dust-free area with the glass at a moderate temperature (not hot from the sun).
2. POSITION THE DECAL
- Carefully peel the backing away from the sticker.
- Place the sticker in your desired location, adhesive side down.
- Avoid touching the adhesive with your fingers as much as possible.
3. APPLY THE DECAL
- Smooth out from the center toward the edges using a squeegee, credit card, or similar flat tool.
- Press firmly to remove any air bubbles.
- If bubbles remain, gently prick with a pin and smooth out.
4. SET & CURE
- Allow 48 hours before exposing to water or using windscreen wipers.
- Apply in dry conditions at room temperature (avoid extreme cold or heat during application).
SUNSTRIP APPLICATION PROCESS
WHAT YOU'LL NEED
- Squeegee or plastic card wrapped in a soft cloth
- Masking tape (for positioning)
- Clean microfiber cloth
- Sharp blade or craft knife (for trimming)
STEP 1: PREPARE THE SURFACE
- Clean the area thoroughly with soap and water.
- Dry completely — moisture, dust, or coatings can prevent proper adhesion.
- Any glass sealants or ceramic coatings will affect adhesion.
- For best results, wipe with rubbing alcohol and let dry.
- Work in a shaded, dust-free area with the glass at a moderate temperature (not hot from the sun).
STEP 2: POSITION THE SUNSTRIP
- Hold the sunstrip up to the glass and use masking tape to mark the position.
- Peel a few inches of backing away from the center of the vinyl.
- Gently tack this section to the windscreen in your chosen position.
STEP 3: APPLY THE SUNSTRIP
- Working from the center outwards, slowly peel more backing while pressing the vinyl down with the squeegee.
- Move side-to-side, pushing out air as you go.
- Take your time — once the vinyl touches the glass it sticks firmly, so repositioning is limited.
STEP 4: TRIM & FINISH
- Once applied, carefully trim away the excess along the windscreen edges with a sharp blade.
- Go over the whole sunstrip with the squeegee to ensure strong adhesion, especially around the cut-out logo.
- Allow 48 hours before washing the vehicle or exposing to heavy rain.
- Do not use wipers for 48 hours after installation